OpenComms

Showing 5

reply the "SET COAX BUILD STATE" Tool, in the Fiber Module

No description provided

over 1 year ago in OpenComms / Engineering Design 0 Shipped

RESERVED SPLITTER PORTS/SLOTS IN THE TRAYS

We have realized that when we add a Tray with 9 ports inside the Splice Enclosures and then we add a splitter (1x4) with 5 Ports (Common, Port1, Port2, Port3, Port4) the Tray reserves only 4 ports instead of 5, which is wrong. Please find attached...

10 months ago in OpenComms / Engineering Design 0 Shipped

4 VOTE

RESERVED TRAY SLOT IN THE FIBER SPLICE ENCLOSURE

We have 2 types of trays 5mm which utilizes one tray slot in the Splice Enclosure and 10 mm tray which utilizes two tray slots. The way we went about this was by creating a "RESERVED TRAY SLOT" tray in the tray Library and whenever we add 10mm tra...

10 months ago in OpenComms / Engineering Design 0 Shipped

1 VOTE

Export info on the Xsection O/S Review dialog

When several O/S are assigned to a single fiber, the Fiber Review of the cable doesn´t show all of them. Even if you export it, it still doesn´t be shown. All the OS of a fiber cable are shown in the Xsection O/S Review. Would it be possible to ex...

7 months ago in OpenComms / Reporting 0 Shipped

1 VOTE

Rotation of equipment inserted into fiber

It seems like equipment inserted between fiber sheaths never comes it at the 'right' rotation (or trimmed correctly, but I tend to blame the person setting up the cells for that more than Bentley software). Would it be possible to get equipment be...

over 1 year ago in OpenComms / Engineering Design 0 Shipped

OpenUtilities Ideas Portal

Please enter your email address

FILTER BY CATEGORY